AutoZone can help you diagnose the cause of the light and help you correct it. In most cases disconnecting the battery for a few minutes then reconnecting will clear the fault codes and turn off the light. But if the issue has not been resolved it will come back on, in some cases almost immediately.
Can I get my check engine light cleared?
Turning the Ignition On and Off
The on-off method is the equivalent fix for a vehicle’s check engine light. It forces the computer to refresh its saved state through a reboot. Simply place your key into the ignition and turn it on for 1-2 seconds, then turn it off for 1-2 seconds. Repeat this step three or four times.
Can auto parts store clear codes?
Go to a local auto parts store like Auto Zone, Advance Auto or Pep Boys to ask for a free OBD code reset if you don’t have a scanner. Most chain auto parts stores offer this service, including reading the codes for you, free of charge.
How far do you have to drive to reset the check engine light?
To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.
How long does it take for a car computer to reset?
The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.
Does disconnecting battery clear codes?
Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. Secure the negative cable back to the terminal and cover it with the cap (if applicable). Disconnecting the battery will clear the error codes and reset the check engine light.
Does AutoZone check engine light?
Does AutoZone Scan Check Engine Lights? AutoZone does. If your light is on, and you are wondering why, head down to your local AutoZone where one of our store associates can help diagnose the issue through our free Fix Finder service.
Does O’Reilly clear codes?
Most major-chain parts stores like AutoZone or O’Reilly’s will read codes set off by your car for free so you can narrow down the list of potential problems. … Parts stores can also clear the codes after they read them, which forces your car to start its search for issues from scratch.
Can Advanced Auto Parts clear codes?
If the code is still stored after replacement and starting the engine, you can manually clear the error code by setting the code reader to erase it from memory. … Code readers are on hand at your local Advance Auto Parts to help you diagnose a vehicle problem.